Label Issue Operation; Where The Saved Data Call Command Is Not Used - Toshiba B-SX4T Series Specification

5.2 LABEL ISSUE OPERATION

An example of the label issue operation is described below.

(1) Where the Saved Data Call Command is not used:

Position Fine Adjust Command
Image Buffer Clear Command
Bit Map Font Format Command
Outline Font Format Command
Bar Code Format Command
Bit Map Font Data Command
Outline Font Data Command
Bar Code Data Command
Yes
Yes
Yes
NOTES: (1) When placing new paper, the Label Size Set Command and the Feed Command must
always be sent. When using the same paper after the power is turned off and on, the
Label Size Set Command and the Feed Command may be omitted.
(2) After the power is turned off and on, the Bit Map Font Format Command, the Outline
Font Format Command, and the Bar Code Format Command should be sent as
occasion demands because they are not protected in memory.
Power ON
Place paper
Label Size Set Command
Print Density Fine
Adjust Command
Feed Command
Line Format Command
Issue Command
<Change data issue>
No
<Format change>
No
<Label change>
No
Power OFF
[ESC] D: Sets the label size.
[ESC] AX: Adjusts the feed length, cut position, and
back feed length.
[ESC] AY: Adjusts the print density.
[ESC] T: Feeds one sheet of paper and aligns it
with the first print position.
[ESC] C: Clears the image buffer.
[ESC] LC: Sets the line format and draws it.
[ESC] PC: Sets the bit map font format.
[ESC] PV: Sets the outline font format.
[ESC] XB: Sets the bar code format.
[ESC] RC: Draws bit map font data.
[ESC] RV: Draws outline font data.
[ESC] RB: Draws bar code data.
[ESC] XS: Issues (prints) the label.
- 32 -