Dhcp Function Set Command - Toshiba B-SX4T Series Specification

6.3.41 DHCP FUNCTION SET COMMAND

Function Enables or disables the DHCP function, and sets the DHCP client ID.
Format [ESC] IH; a, bbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb [LF] [NUL]
Term a:
bbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb: DHCP client ID
Explanation • These settings can also be made in the system mode. The setting which was last
made takes effect.
• "FFH" in the client ID is assumed as a terminator. Therefore, "FFH" must not be
used in data.
• If "FFH" is specified as the first byte of the DHCP client ID, the printer assumes the
DHCP client ID is not specified, and uses the MAC address of the LAN board installed
on the printer as the DHCP client ID.
Example To enable the DHCP function and set the DHCP client ID to "12H56HCDH".
[ESC] IH; 1, 1256CDFFFFFFFFFFFFFFFFFFFFFFFFFF [LF] [NUL]
0: DHCP function is disabled.
1: DHCP function is enabled.
- 236 -
[ESC] IH
(16 bytes of data should be described in 32
bytes in Hex.)