11.3 AUTO CONFIGRATION FILE
To execute the auto configuration mode, it is required to create the auto configuration file, which is an
exclusive CFG file, in the USB memory in advance.
The auto configuration file is stored under the following path under the name of "AUTO CONFIG.CFG".
/ATA0/SYSTEM/AUTOCONFIG.CFG
11.3.1 Format
Auto configuration file has the following formats.
B-EX4T1-G,0020
B-EX4T1-T C1.0A
/ATA0/SYSTEM/B-EX-BOOT-Vx.x-xx.bin
/ATA0/SYSTEM/B-EX-MAIN-Vx.x-xx.bin
/ATA0/SYSTEM/B-EX-CG-Vx.x-xx.bin
11.3.2 Model Information
Information for applicable models is stored.
The information is comma separated. The first half is the model name (the above example indicates
B-EX4T Type 1 203-dpi model) and the last half is the PC board information.
If the actual printer and this model information do not match, the auto configuration mode will not start.
Description of the model information:
B-EX4T1-T,0020
PC board information
Resolution
G: 203 dpi
T: 300/305 dpi
H: 600 dpi
Model
B-EX4T1: B-EX4T1-G/T
B-EX4T2: B-EX4T2-G/T
B-EX4T2H: B-EX4T2-H
B-EX4D2: B-EX4D2-G
B-EX4T3: B-EX4T3-H
11.3.3 Display Message
A message displayed on the LCD while the printer is in the auto configuration mode.
The word-wrap feature is enabled.
Only characters that can be expressed with ASCII are allowed to be input.
11.3.4 Firmware File to be Downloaded
Name of the file to be downloaded
0020: QM/CN/QQ model
0021: B-EX4T3-HS
0023: B-EX4T3-HS ROM expansion board
Model information
Display message
Firmware file to be downloaded
Firmware file to be downloaded
Firmware file to be downloaded
183