Fine Adjustment Value Set Command - Toshiba B-SX4T Series Specification

6.4.2

FINE ADJUSTMENT VALUE SET COMMAND

Function Sets various fine adjustment values on the printer.
Format [ESC] Z2; 2, abbbcdddeffghhhijjkllmnnoppqqrr [LF] [NUL]
Term a:
bbb: Feed length fine adjustment value
c:
ddd: Fine adjustment value for the cut position (or strip position)
e:
ff:
g:
hhh: X-coordinate fine adjustment value
i:
jj:
k:
ll:
m:
nn:
Indicates the direction, forward or backward, in which a feed length fine
adjustment is to be made.
+: Backward
-: Forward
000 to 500 (in units of 0.1 mm, in steps of 0.5 mm)
Indicates the direction, forward or backward, in which a cut position (or strip
position) fine adjustment is to be made.
+: Backward
-: Forward
000 to 500 (in units of 0.1 mm, in steps of 0.5 mm)
Indicates whether the back feed is to be increased or decreased.
+: Increase
-: Decrease
Back feed length fine adjustment value
00 to 95 (in units of 0.1 mm, in steps of 0.5 mm)
Indicates the direction, positive or negative, in which the X-coordinate fine
adjustment is to be made.
+: Positive direction
-: Negative direction
000 to 995 (in units of 0.1 mm, in steps of 0.5 mm)
Indicates whether to increase or decrease the density in the thermal transfer print
mode.
+: Increase (darker)
-: Decrease (lighter)
Print density fine adjustment value (for the thermal transfer print mode)
00 to 10 (in units of 1 step)
Indicates whether to increase or decrease the density in the direct thermal print
mode.
+: Increase (darker)
-: Decrease (lighter)
Print density fine adjustment value (for the direct thermal print mode)
00 to 10 (in units of 1 step)
Fine adjustment direction for the ribbon rewind motor voltage
-: Fixed as Negative (The voltage is lowered.)
Fine adjustment value for the ribbon rewind motor voltage
00 to 15 (in units of 1 step)
[ESC] Z2; 2
- 243 -
(*1)
(*1)
(*1)
(*1)