Download Print this page

Advertisement

sEAT BELTs
(2/3)
1
3
5
Locking
Unwind the belt slowly and smoothly
and ensure that buckle 3 locks into
catch 5 (check that it is locked by pull-
ing on buckle 3). If the belt jams, allow
it to return slightly before attempting to
unwind it again.
If your seat belt is completely jammed,
pull slowly, but firmly so that just over
3 cm unwinds. Allow it to return slightly
before attempting to unwind it again.
If there is still a problem, contact an ap-
proved dealer.
1.20
front seat belt reminder
warning light
This comes on when the engine is
started, then, if the driver's or front pas-
senger's seat belt is not fastened (if
this seat is occupied) and the vehicle
has reached approximately 12 mph (20
km/h), it flashes and a beep sounds for
around 2 minutes.
Note: an object placed on the passen-
ger seat base may activate the warning
light in some cases.
4
Rear seat belt reminder
5
The number of rear seat belts fastened
appears on instrument panel for ap-
proximately 30 seconds each time:
– the vehicle is started;
– a door is opened;
– a rear seat belt is fastened or unfas-
tened.
Check that the rear passengers are
wearing seat belts and that the number
of seat belt shown as fastened corre-
sponds to the number of rear bench
seats occupied.
Unfastening
Press button 4 and the seat belt will be
rewound by the inertia reel. Guide the
belt into position.
6
Adjusting the front seat belt
height
Press button 6 to adjust the seat belt
height so that the shoulder strap 1 is
worn as shown previously:
– to lower the seat belt, press button 6
and lower the seat belt at the same
time;
– to raise the seat belt, push control 6
upwards.
Make sure that the seat belt is locked
in position correctly after you have ad-
justed it.

Advertisement

Chapters

Comments to this Manuals

Symbols: 0
Latest comments: