Fuse box 2
If any electrical component does not
work, check the condition of the fuses.
Open storage compartment A. Press
tab 1 to move it then pull it towards you
to unclip it.
To identify the fuses, refer to the fuse
allocation label (shown on the following
Check the fuse in question
and replace it, if neces-
sary, by a fuse of the same
If a fuse is fitted where the rating is
too high, it may cause the electrical
circuit to overheat (risk of fire) in the
event of an item of equipment using
an excessive amount of current.
Remove the fuse using tweezers 3, lo-
cated at the back of storage compart-
To remove the fuse from the tweezers,
slide the fuse to the side.
It is not advisable to use the free fuse
In accordance with local legislation
or as a precautionary measure:
Obtain an emergency kit containing
a set of spare bulbs and fuses from
an approved Dealer.