fRONT sEATs WITH ELEcTRIc cONTROL
Switch 3 is used for adjusting the seat-
back and switch 4 is used for adjusting
the seat squab.
On equipped vehicles, buttons 2 are
used to store the chosen driving posi-
tion (refer to the following page).
Adjusting the seat squab:
– To move the seat forwards or back
Move switch 4 forwards or back-
– To raise or lower the rear of the
Move the rear of switch 4 upwards or
– To raise or lower the front of the
Move the front of switch 4 upwards
Adjusting the lumbar support
on the driver's seat:
Lower handle 5 to increase the support
and lift to decrease it.
Adjusting the seatback:
To tilt the seatback, move the top of
switch 3 forwards or backwards.
(depending on vehicle)
With the engine running, turn control 1
to either position 1, 2 or 3 (depending
on the temperature required). An in-
dicator light on the instrument panel
lights up once the front seat heating
system is operating.
The system, which has a thermostat,
decides whether or not the heating is
For safety reasons, carry
out any adjustments when
the vehicle is not being
We would advise you not to recline
the seatbacks too far to ensure that
the effectiveness of the seat belts is
Nothing should be placed on the
floor (area in front of driver) as such
objects may slide under the pedal
during braking manoeuvres, thus
obstructing its use.