Dell PowerConnect B-RX Configuration Manual page 242

7
Configuring IP parameters
BigIron RX# show ipv6 tunnel
IP6 Tunnels
Tunnel
1
2
Syntax: show ipv6 tunnel
This display shows the following information.
TABLE 46
This field...
Tunnel
Mode
Packet Received
Packet Sent
Displaying tunnel interface information
For example, to display status and configuration information for tunnel interface 1, enter the
following command at any level of the CLI.
BigIron RX# show interfaces tunnel 1
Tunnel1 is up, line protocol is up
Hardware is Tunnel
Tunnel source ethernet 3/5
Tunnel destination is not configured
Tunnel mode ipv6ip auto-tunnel
No port name
MTU 1500 bytes
Syntax: show interfaces tunnel <number>
The <number> parameter indicates the tunnel interface number for which you want to display
information.
This display shows the following information.
TABLE 47
This field...
Tunnel interface status
Line protocol status
Hardware is tunnel
170
Mode Packet Received
configured 0
configured 0
IPv6 tunnel information
Displays...
The tunnel interface number.
The tunnel mode. Possible modes include the following:
•
•
•
The number of packets received by a tunnel interface.
The number of packets sent by a tunnel interface.
IPv6 tunnel interface information
Displays...
The status of the tunnel interface can be one of the following:
•
up – The tunnel interface is functioning properly.
•
down – The tunnel interface is not functioning and is down.
The status of the line protocol can be one of the following:
•
up – The line protocol is functioning properly.
•
down – The line protocol is not functioning and is down.
The interface is a tunnel interface.
Packet Sent
0
22419
configured – Indicates a manually configured tunnel.
6to4 – Indicates an automatic 6to4 tunnel.
auto – Indicates an automatic IPv4-compatible tunnel.
BigIron RX Series Configuration Guide
53-1001986-01