Bulk Configuration Examples - Dell Z9000 Configuration Manual

The show configuration command is also available under Interface Range mode. This command
allows you to display the running configuration only for interfaces that are part of interface range.

Bulk Configuration Examples

Use the interface range command for bulk configuration.
• Create a Single-Range
• Create a Multiple-Range
• Exclude Duplicate Entries
• Exclude a Smaller Port Range
• Overlap Port Ranges
• Commas
• Add Ranges
Create a Single-Range
The following is an example of a single range.
Example of the interface range Command (Single Range)
Dell(config)# interface range gigabitethernet 0/1 - 23
Dell(config-if-range-gi-0/1-23)# no shutdown
Dell(config-if-range-gi-0/1-23)#
Create a Multiple-Range
The following is an example of multiple range.
Example of the interface range Command (Multiple Ranges)
Dell(conf)#interface range tengigabitethernet 0/5 - 10 , tengigabitethernet
0/1 , vlan 1
Dell(conf-if-range-te-0/5-10,te-0/1,vl-1)#
Exclude Duplicate Entries
The following is an example showing how duplicate entries are omitted from the interface-range prompt.
Example of the Interface-Range Prompt for Duplicate Interfaces
Dell(conf)#interface range vlan 1 , vlan 1 , vlan 3 , vlan 3
Dell(conf-if-range-vl-1,vl-3)#
Dell(conf)#interface range gigabitethernet 2/0 - 23 , gigabitethernet 2/0 -
23 , gigab 2/0 - 23
Dell(conf-if-range-gi-2/0-23)#
Exclude a Smaller Port Range
The following is an example show how the smaller of two port ranges is omitted in the interface-range
prompt.
Example of the Interface-Range Prompt for Multiple Port Ranges
Dell(conf)#interface range gigabitethernet 2/0 - 23 , gigab 2/1 - 10
Dell(conf-if-range-gi-2/0-23)#
342
Interfaces