Testing Presentation Devices - Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual

Chapter 9 Troubleshooting the CTS 3000 and CTS 3200

Testing Presentation Devices

The output for presentations is handled by projectors or auxiliary
can be delivered through a Video Graphics Array (VGA) input device (such as a laptop computer) or
through a document camera.
Note You should run this test only if you have presentation display devices installed.
Table 9-5
Table 9-5 Supported Presentation Devices
Presentation Device
Projector
Document Camera
Auxiliary Display—40" LCD
The projector is set up successfully when the test pattern is displayed on the projection surface in the
meeting room while running the test.
Tip When troubleshooting presentation devices, start with the projector test pattern to see if the projector is
set up correctly and then proceed through VGA and other tests as necessary.
Use the information in the following sections to test presentation devices:
•
•
•
•
•
•
OL-21845-01
contains supported presentation devices listed by system.
Included in Cisco TelePresence System
• CTS 3000
CTS 3200
•
—
—
Checking the Test Pattern, page 9-24
Checking the VGA, page 9-25
Checking the Document Camera, page 9-25
Testing the Projector, page 9-25
Troubleshooting Presentation Devices, page 9-33
Related Information, page 9-35
Managing CTS 3000 and CTS 3200 Hardware Setup
LCD displays. Input to the projector
Optional in Cisco TelePresence System
—
—
• CTS 3000
• CTS 3200
Cisco TelePresence System Administration Guide
9-23