Supported Cts Devices; Supported Cts Software; Supported Satellite Bandwidth; Satellite Security - Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual

Telepresence system
Hide thumbs Also See for CTS 1000 - TelePresence System 1000 Video Conferencing:
Table of Contents

Advertisement

Cisco TelePresence over Satellite Networks

Supported CTS Devices

The CTS 1000, CTS 1100, CTS 1300, and CTS 500 endpoint models are supported as the remote
endpoint on the far end of a satellite link.
Other endpoint models (CTS 3000 and CTS 3200) have not been qualified to work on the remote side of
a satellite link because the bandwidth needed for these three-screen systems quickly becomes
cost-prohibitive to run over satellite networks. Any Cisco TelePresence endpoint or mix of endpoints (for
a multipoint call) can be used on the terrestrial side of the satellite link.

Supported CTS Software

You must be running CTS software version 1.5 or a later release on all Cisco TelePresence endpoints,
Cisco TelePresence Multipoint Switches, and Cisco TelePresence Managers within your network to
participate in a satellite call.

Supported Satellite Bandwidth

You will need a minimum of 3-MB bandwidth (at 720p, good motion handling) in a
single-channel-per-carrier (SCPC) configuration over a single-hop satellite link.
Because the Cisco TelePresence video and audio are traveling up to the satellite and back down to an
Note
earth station, significant (500 ms or more) latency is introduced into the signal. The result is noticeable
delay in the conversation. In addition, atmospheric conditions or other interference may impact
satellite-link performance and introduce jitter or packet loss into the call. The result may be noticeable
degradation of the video quality.
CTS software release 1.5 and later releases support satellite deployment configurations that significantly
raise the thresholds for network warning messages and call termination. When a satellite endpoint joins
a call (point-to-point or multipoint), all other endpoints in the call negotiate the new threshold setting,
so no one in the call gets warning messages or gets dropped just because a satellite-based endpoint joins
the call.

Satellite Security

The Cisco TelePresence application supports Transport Layer Security (TLS) and Secure Real-Time
Transport Protocol (SRTP) encryption for signaling and media paths.
Cisco TelePresence System Administration Guide
A-2
Supported Satellite Bandwidth, page A-2
Satellite Security, page A-2
Appendix A
Satellite Licenses for the Cisco TelePresence System
OL-21845-01

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Cts 3210Cts-3010

Table of Contents