Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 177

Chapter 7 Troubleshooting the CTS 1100
•
•
•
•
•
•
Removing the Camera Cover and Leveling the Camera
The camera cluster must be perfectly level for you to properly configure the camera. To level the camera,
complete the following steps.
Turn the four black plastic screws on the top and bottom of the camera assembly 1/4 turn, then remove
Step 1
the camera cover, as shown in
Figure 7-3
Step 2 Place the small
camera cluster until the camera assembly is level, as shown in
OL-21845-01
Attaching the Large Camera Target to the Easel
Positioning the Table and Starting the Calibration Procedure
Managing Focus Adjustments and Adjusting the Camera Zoom, page 7-10
Focusing the Camera
Saving Your Settings
Attaching the Camera Lens and Hood
Removing the Camera Cover
Cover
release
screws
Cover
release
screws
spirit level on top of the camera assembly and adjust the leveling screws behind the
Figure 7-3.
Cisco TelePresence System Administrator Guide
Managing CTS 1100 Hardware Setup
Figure 7-4.
7-7