Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 183

Chapter 7 Troubleshooting the CTS 1100
Figure 7-10
Camera
rotation
screw
• The top two screws provide adjustment to the right and left. Use a 2.5 mm Allen wrench for these
screws.
The lower screw provides up and down adjustment. Use a 2.5 mm Allen wrench for this screw.
•
The screws in the middle adjust the camera rotation. Use a 3 mm Allen wrench for these screws.
•
Step 11 Adjust the camera zoom by completing the following steps:
a. Loosen the thumbscrew for the zoom ring on the camera lens.
Note
b. Adjust the camera zoom so that the black curved lines on each side of the target touch the edge of
the display screen.
c. After you adjust the zoom, make any required adjustments to the focus with the focus ring, as shown
in
OL-21845-01
Camera Adjustment Screws
Left
adjust
screw
Up/down
adjust
screw
The zoom ring is labeled "W-T".
Figure 7-11.
Right
adjust
screw
Camera
rotation
screw
Cisco TelePresence System Administrator Guide
Managing CTS 1100 Hardware Setup
7-13