Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 181

Chapter 7 Troubleshooting the CTS 1100
Step 3 Using a supported Internet browser, log in to the Cisco TelePresence System Administration interface.
Step 4 Choose Troubleshooting > Hardware Setup
Step 5 Click the Cameras radio button, as shown in
Figure 7-8
Step 6 Click Start to start the camera test.
Step 7 Click Show Camera Target. The Camera Target menu appears.
The display projects the image from the camera, with the addition of a red plus sign in the center of the
display.
Step 8 Automatically adjust the camera by completing the following steps:
a. In the Auto Brightness field, perform one of the following actions:
•
•
b. In the Auto Color Balance field, perform one of the following actions:
•
•
c. In the 50 Hz Flicker Reduction field, click the Disable radio button.
OL-21845-01
Camera Menu
If the room uses outside lighting, or has any other conditions that could cause variable room
lighting, click the Enable radio button.
If your room lighting is not variable, leave the default value.
If the room uses outside lighting, or has any other conditions that could cause variable room
lighting, click the Enable radio button.
If your room lighting is not variable, leave the default value.
Managing CTS 1100 Hardware Setup
Figure 7-8.
Cisco TelePresence System Administrator Guide
7-11