Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 256
Telepresence system
Hide thumbs
Also See for CTS 1000 - TelePresence System 1000 Video Conferencing:
- Hardware options & upgrade manual (142 pages)
Table of Contents
Advertisement
Managing CTS 1300 Hardware Setup
Step 4
Position the small camera target by completing the following steps:
a.
b.
Position the large target by completing the following steps:
Step 5
a.
b.
c.
Note
d.
e.
Step 6
Adjust the focus on the left camera by completing the following steps:
a.
b.
Note
c.
d.
Note
The red and green bars do not have to be exactly the same length, but get them as close as you can.
e.
Step 7
Click Done to complete the right camera focusing procedure.
Saving Your Settings
When you have configured all your settings:
Step 1
Click Apply to register new or modified settings.
Step 2
Click Reset to restore the original settings.
For more information about testing and troubleshooting the CTS 1300, see the
section in the
Field-Replacement Unit
Cisco TelePresence System Administration Guide
8-44
Place the target on the table one foot from the edge where the participants sit.
Position the target so that the topmost patterns on the target are enclosed in the green box.
Remove the large focus target from the easel.
Rotate the target 90 degrees.
Have another person hold the target upright.
If another person is not available, clamp the top of the target into the clamp at the top of the easel.
Place the top of the easel five feet behind the top of the small target.
Position the target so that the topmost patterns are enclosed in the red box.
Loosen the thumbscrew for the lens focus ring.
Twist the focus ring clockwise until the red and green horizontal bars on the bottom of the screen
are reduced to very short lengths on the left.
Figure 8-35
shows a mirror image of the horizontal bars.
Twist the focus ring counter-clockwise until the red and green bars extend all the way to the right.
Continue to twist the focus ring until the red and green bars are approximately the same length. See
Figure 8-35
to view the approximate horizontal bar alignment. When the bars are roughly the same
length, the camera is focused.
Without moving the focus ring, tighten its thumbscrew.
First-Time Setup
Guide.
chapter of the
Cisco TelePresence 1300 Assembly, Use & Care, and
Chapter 8
Troubleshooting the CTS 1300
Setting Up the Camera
OL-21845-01
Advertisement
Table of Contents
Troubleshooting
