Managing CTS 500 Hardware Setup
Testing Speakers
The speakers are set up successfully when sound can be heard clearly from each one. When running a
test, you can choose whether to cycle through the speakers automatically or manually.
Use the information in the following sections to test the speakers for your system:
•
•
•
Testing the Speakers
To test the speakers:
Step 1
Log in to the Cisco TelePresence System Administration interface.
Step 2
Choose Troubleshooting > Hardware Setup
Step 3
Click the Speakers radio button.
Step 4
Click Start to begin the speaker test. The speaker test screen appears, as shown in
Figure 4-14
Speaker Test Screen
Click Cycle Through Speakers to have sound cycled automatically for 5 seconds on each speaker.
Step 5
Click Manually Step Through Speakers to test sound on each speaker. The Next Speaker button is
Step 6
activated.
Click Next Speaker to progress to the next speaker.
Step 7
Cisco TelePresence System Administration Guide
4-22
Testing the Speakers, page 4-22
Troubleshooting Speakers, page 4-23
Related Information, page 4-23
Chapter 4
Troubleshooting the CTS 500
Figure 4-14
OL-21845-01