Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 138

Managing CTS 1000 Hardware Setup
Removing the Camera Hood
Removing the camera hood provides access to the zoom and focus rings for the camera. To remove the
camera hood:
Step 1 Find the two screw holes in the bottom of the camera hood and unscrew the two M4 x 10 mm screws.
Step 2 Remove the hood from the camera.
Assembling and Setting Up the Camera Targets
The Cisco TelePresence System uses targets to set focus and camera alignment and to help with color
balance. Two targets are used. This section describes how to assemble and set up the camera targets.
To assemble and set up the camera targets:
Step 1 Carefully open the box containing the two targets and the target frame components. The frame elements
are in the bottom of the box.
Note Take care not to damage the box. When you are finished with the camera adjustment procedure, you can
disassemble and store the target in the box for future use.
Step 2 Lay the two metal frames on the floor.
Step 3 Attach the two frame pieces with the screws.
Step 4 Locate the horizontal center point in the Cisco TelePresence System 1000 frame and mark the
corresponding point on the table.
Step 5 Attach the camera target frame to the table by tightening the clamps to the table edge, as shown in
Figure
should be facing the camera.
The edge of the table should be 4 to 8 feet (1.2 to 2.4 meters) from the camera.
Tip
Cisco TelePresence System Administration Guide
6-8
6-3. The target should be attached on the side of the table where the participants sit and the target
Chapter 6 Troubleshooting the CTS 1000
OL-21845-01