Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 81

Chapter 4 Troubleshooting the CTS 500
Figure 4-5
Large
target
Easel
Raise or lower the CTS 500 so that the green rectangle that displays on the screen is at the approximate
Step 8
eye level of the CTS 500 user.
If you have a wall-mounted CTS 500, skip this step.
Note
Use the following guidelines when raising and lowering the stand (see
• Do not grasp the light reflector, or any part of the CTS 500 but the monitor.
Use two hands.
•
• Do not lift using only one side.
• Apply equal pressure from each side.
OL-21845-01
Camera Target Placement
5 ft
(1.5 m)
Managing CTS 500 Hardware Setup
Height
adjustment
knob
Figure 4-6
Cisco TelePresence System Administration Guide
and Figure 4-7):
4-9