Troubleshooting Your Configuration - Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual

Chapter 3 Configuring the Cisco TelePresence System
Table 3-5
Field
Display On Time
Display On Duration
Note
NTP Servers
NTP Server 1 through 5
Step 3 Use Cisco Unified CM to make changes to the system settings. See the
Manager Configuration Guide for the Cisco TelePresence System

Troubleshooting Your Configuration

Use the information in
Before You Begin
First check that the following conditions have been met:
•
•
•
OL-21845-01
System Settings (continued)
Description or Setting
Specifies the time of day that the Cisco TelePresence system display(s)
will remain on after being turned on, if CCM is configured. Times are
displayed in a 24-hour format where 00:00 indicates 12:00 midnight and
23:59 indicates 11:59 pm. Default is 07:30.
If you clear the default value so that the field is blank, the display(s) will
turn off after the completion of each call.
Specifies the length of time the Cisco TelePresence system display(s) will
remain on if a "Display On Time" value is defined. Times are displayed in
a 24-hour format, where 1:30 indicates one hour and thirty minutes; the
maximum value is 24:00 (24 hours). Default is 10:30.
If you clear the default value so that the field is blank, then the display will
turn off at 11:59 pm.
If your version of Cisco Unified CM does not allow you to configure values for Days Display
Not Active, Display On Time or Display On Duration, the system uses the default values for
these features.
Network Time Protocol (NTP) is used to synchronize the clocks on
Cisco IP telephony servers with an external network time server that uses
NTP. You can have up to five IP addresses for Network Time Protocol
servers.
Note
Table 3-6
Power has been applied.
The Cisco TelePresence System has been installed and configured according to the instructions in
Cisco TelePresence System Assembly Guides.
Cisco Unified CM has been configured to support the Cisco TelePresence System as described in
the Cisco Unified Communications Manager Configuration Guide for Cisco TelePresence System.
NTP must be configured properly to ensure that calendar events
appear as expected.
to help you troubleshoot your configuration.
Cisco TelePresence System Administration Guide
Troubleshooting Your Configuration
Cisco Unified Communications
for more information.
3-21