Managing CTS 500 Hardware Setup
Log in to the Cisco TelePresence System Administration interface.
Step 1
Choose Troubleshooting > Hardware Setup.
Step 2
Click the Other Devices radio button.
Step 3
Select the Light tab.
Step 4
Step 5
Click Start in the Testing box. The CTS 500 light status is displayed, as shown in
Figure 4-19
CTS 500 Light Status
•
•
Click the Light State On or Light State Off button to change the current state of the shroud light.
Step 6
Click Stop to end the test. The state of the light reverts to its default setting as it was configured in the
Step 7
Cisco Unified CM.
Digital Media Player
The Digital Media Player (DMP) feature lets you select a secondary audio input source when you are
not in a TelePresence call.
To test the DMP:
Log in to the Cisco TelePresence System Administration interface.
Step 1
Step 2
Choose Troubleshooting > Hardware Setup.
Step 3
Select the DMP tab.
Cisco TelePresence System Administration Guide
4-36
If the shroud light feature is enabled, the Light State On button will be highlighted.
If the shroud light feature is disabled, the Light State Off button will be highlighted.
Chapter 4
Troubleshooting the CTS 500
Figure
4-19.
OL-21845-01