Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 142

Managing CTS 1000 Hardware Setup
Step 8 Click Remove Camera Target to stop the test, as shown in
Figure 6-5
Step 9 Proceed to the following sections:
• Tuning the Camera, page 6-13
Setting the Camera Yaw, page 6-14
•
Adjusting the Pan of the Camera, page 6-14
•
Adjusting the Tilt of the Camera, page 6-15
•
Cisco TelePresence System Administration Guide
6-12
Remove Camera Target
Chapter 6 Troubleshooting the CTS 1000
Figure 6-5.
OL-21845-01