Checking The Vga; Checking The Document Camera; Testing The Projector - Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual

Chapter 9 Troubleshooting the CTS 3000 and CTS 3200

Checking the VGA

To check the
Log in to the Cisco TelePresence System Administration interface.
Step 1
Choose Troubleshooting > Hardware Setup.
Step 2
Click the Presentation Devices radio button.
Step 3
Click Start in the Testing box. The Presentation Source buttons are activated.
Step 4
Select VGA and click Test. It may take up to 15 seconds before you begin to see an image on the
Step 5
projection surface. The image should be fully formed after approximately 45 seconds.
If the input image is displaying correctly, you should see an image projected on the projection surface.
If the image is out of focus, use the projector focus ring to focus the image.
Click Stop Test to end the test.
Step 6
Click Set Projector Defaults to reset the projector to the default settings.
Step 7
Click Stop in the Testing box to end all testing.
Step 8

Checking the Document Camera

To test input from the document camera (if available):
Step 1 Log in to the Cisco TelePresence System Administration interface.
Step 2 Choose Troubleshooting > Hardware Setup.
Step 3 Click the Presentation Devices radio button.
Click Start in the Testing box. The Presentation Source buttons are activated.
Step 4
Select Document Camera and click Test. It may take up to 15 seconds before you begin to see an image
Step 5
on the projection surface. The image should be fully formed after approximately 45 seconds.
If the input image is displaying correctly, you should see an image projected on the projection surface.
If the image is out of focus, use the projector focus ring to focus the image.
Step 6 Click Stop Test to end the test.
Click Set Projector Defaults to reset the projector to the default settings.
Step 7
Step 8 Click Stop in the Testing box to end all testing.

Testing the Projector

This section contains projector tests for the following devices:
•
•
•
OL-21845-01
VGA on the CTS 3200:
Testing the CTS 3000 Projector - With an Auxiliary Control Unit, page 9-26
Testing the CTS 3000 Projector - Systems Without an Auxiliary Control Unit, page 9-27
Testing the CTS 3200 Projector, page 9-31
Managing CTS 3000 and CTS 3200 Hardware Setup
Cisco TelePresence System Administration Guide
9-25