Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 139

Chapter 6 Troubleshooting the CTS 1000
Figure 6-3
Unfold the large cardboard target.
Step 6
Step 7 Insert the cardboard into the channels on the frame with the printed side facing the display.
Step 8 Push the target into the frame until the two registration marks on the upper right and left edges match
the ends of the top metal frame. See
To identify the corresponding point on the table, you can measure the distance from a side wall to the
Tip
center point in the frame then from the same wall apply the measurement to the table.
On the edge of the table across from the wall, align the vertical line in the target with the center point in
Step 9
the frame.
Step 10 Fit the clamp ends of the target fixture over the table top and tighten the screws to secure.
OL-21845-01
Target Attached to the Tabletop Edge
Figure 6-3.
Cisco TelePresence System Administration Guide
Managing CTS 1000 Hardware Setup
6-9