Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 345

Chapter 10 Troubleshooting the CTS 3010 and CTS 3210
d. Place the small target on the table in front of the large target, and adjust the focus by completing the
steps in the
e. Remove the large target from the center part of the table, and attach it to the left part of the table,
placing the underside of the clamps into the recessed holes.
f. Make manual adjustments to the camera focused on the target and the zoom ring on the camera to
make the following adjustments to the camera:
•
•
•
Tip
Figure 10-6
g. Place the small target on the table, in front of the large target, and adjust the focus by completing
the steps in the
h. Remove the large target from the center part of the table, and attach it to the right part of the table,
placing the underside of the clamps into the recessed holes.
Make manual adjustments to the camera focused on the target and the zoom ring on the camera to
i.
make the following adjustments to the camera:
•
•
•
OL-21845-01
"Focusing the Camera" section on page
Align the red plus sign to the plus sign in the middle of the target.
Align the red hash marks on the display so that they fit between the table edges.
Zoom and align the camera so that the curved line on the right side of the display touches the
red adjustment line at the right edge of the display as shown in
To adjust the camera left and right or up and down, or to make vertical adjustments, use the
adjusting screws as shown in

If one of the left/right screws is covered by the camera cable, use the other screw to make all
left/right adjustments.
Correct Camera Target Alignment—Right Display
"Focusing the Camera" section on page
Align the red plus sign to the plus sign in the middle of the target.
Align the red hash marks on the display so that they fit between the table edges.
Zoom and align the camera so that the curved line on the left side of the display touches the red
adjustment line at the right edge of the display
Managing CTS 3010 and CTS 3210 Hardware Setup
10-12.
10-4. 
Figure
10-12.
Figure 10-7.
Cisco TelePresence System Administration Guide
Figure 10-6.
Red
Vertical line
Red plus
sign within
black cross
Red lines
Table
edge
10-11