Arranging The Seat Alignment Guides - Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual

Chapter 8 Troubleshooting the CTS 1300

Arranging the Seat Alignment Guides

Conference participants should be seated in an area that is completely within the field of view of one of
the three cameras. To ensure this requirement, Cisco provides you with Seat Alignment Guides. After
you set up the cameras, you place these guides on the table; these guides show the field of view for each
camera.
To place the seat alignment guides on the table:
Using a supported Internet browser, log in to the Cisco TelePresence System administration interface.
Step 1
Step 2 Select the correct table type by completing the following steps:
Step 3 Navigate to Troubleshooting > Hardware Setup
Step 4 Click the Cameras radio button.
Step 5 Click Start to display the image of the cameras in the displays.
Step 6 Note the field of view for each camera.
Step 7 Using non-marking tape (for example, masking tape), tape a mark on the table that denotes the edge of
the field of view for each camera.
Place this mark approximately 18 inches (46 cm) from the edge of the table, and point the line of tape at
the camera.
Tip If you cannot determine the camera range, use this guide for marking the table: The focal range of the
center segment is approximately 5 feet (152 cm) wide from where the participants sit. The focal range
of each side segment is approximately 4 feet six inches (137 cm) wide.
Mark the table in four places:
•
•
•
•
Note If your table is narrow, omit the two markings on the outer edges.
OL-21845-01
Edge of camera view, left camera
Edge of view between left and center camera
Edge of view between center and right camera
Edge of camera view, right camera
Managing CTS 1300 Hardware Setup
Cisco TelePresence System Administration Guide
8-45