Related Information - Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual

SNMP Settings
Table 3-4
Field
Engine ID
SNMP Configuration
Trap Receiver Configuration
Use Cisco Unified CM to make changes to the SNMP settings. See the
Step 3
Manager Configuration Guide for the Cisco TelePresence

Related Information

For more information about SNMP, see the following information on Cisco.com:
•
•
Cisco TelePresence System Administration Guide
3-18
SNMP Settings
MIBs, RFCs, and SNMP Trap Messages for the Cisco TelePresence System
Simple Network Management Protocol (SNMP)
Chapter 3
Settings
Identifies the local or remote SNMP engine. The remote agent
SNMP engine ID and user password are used to compute
authentication and privacy digests.
Parameters that access the SNMP server associated with this
Cisco TelePresence System. Cisco Unified CM for CTS supports
SNMP Version 2c and Version 3. SNMP fields displayed in this
window reflect the configured SNMP version. The following fields
are included:
SNMP Enabled
•
User ID
•
Security Level
•
Authentication Algorithm
•
Encryption
•
System Location
•
System Contact
•
• Read-Only Community String
• Read-Write Community String
SNMP settings for the receiver to which this Cisco TelePresence
system will send traps. The following information is shown for
Traps 1 through 5:
• Trap Receiver
• IP Address
• User ID
• Security Level
• Authentication Algorithm
• Encryption
Community String
•
System.
home page.
Configuring the Cisco TelePresence System
Cisco Unified Communications
OL-21845-01