Auxiliary Control Unit; Digital Media Player - Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual
Telepresence system
Hide thumbs
Also See for CTS 1000 - TelePresence System 1000 Video Conferencing:
- Hardware options & upgrade manual (142 pages)
Table of Contents
Advertisement
Chapter 9
Troubleshooting the CTS 3000 and CTS 3200
Auxiliary Control Unit
The auxiliary control unit (ACU) controls the individual light units surrounding the displays in CTS
conference rooms and enables the CTS to get more complete projector status information and to restores
projector defaults.
To test the ACU:
Step 1
Log in to the Cisco TelePresence System Administration interface.
Step 2
Choose Troubleshooting > Hardware Setup.
Step 3
Click the Other Devices radio button.
Step 4
Click Start in the Testing box. The Auxiliary Control Unit (Current Status) is displayed. Individual light
units correspond to the five port numbers of the Auxiliary Control Unit, Ports 1 through 5.
a.
b.
c.
d.
e.
Click Stop to end the test.
Step 5
Digital Media Player
The Digital Media Player (DMP) feature lets you select a secondary audio input source when you are
not in a TelePresence call.
To test the DMP:
Step 1
Log in to the Cisco TelePresence System Administration interface.
Step 2
Choose Troubleshooting > Hardware Setup.
Step 3
Click the DMP tab.
Click Start in the Testing box to begin testing the secondary audio input.
Step 4
•
•
Note
The DMP settings should match how the secondary auxiliary audio input is physically connected to the
codec.
OL-21845-01
Check a box to select a specific port number.
Or
Click Select All to select all ports (and all light units) or Select None.
Click the Refresh On/Off Status button to update the on/off status of each port.
Click the Turn Selected Lights On/Off to test the selected light unit(s).
Click the Reset Auxiliary Control Unit to power cycle the Auxiliary Control Unit.
If you have a PC attached, the Secondary Audio Input Source PC button is highlighted. When
Secondary Audio Input Source is set to PC, the audio input is active while the presentation source
is active, both in and out of a call.
If you have a DMP attached, the Secondary Audio Input Source DMP button is highlighted. When
set to DMP, audio input is only active outside of a call if DMP is active (during business hours
defined by Cisco Unified CM).
Managing CTS 3000 and CTS 3200 Hardware Setup
Cisco TelePresence System Administration Guide
9-37
Advertisement
Table of Contents
Troubleshooting
