Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 251

Chapter 8 Troubleshooting the CTS 1300
Figure 8-32
Tighten the thumbscrews for the zoom and focus rings.
Step 7
Click Hide Camera Targets to remove the alignment images.
Step 8
Click the Setup button, then click the Auto Adjust button.
Step 9
The auto adjust procedure completes. This procedure takes several seconds.
Note If there is insufficient light, the auto adjust procedure terminates. In this case, add more light to the room
and repeat the auto adjust procedure.
Click Done to complete the procedure.
Step 10
Calibrating the Left Camera
To adjust the zoom and focus the left camera.
Note The directions left and right refer to the assembly as you face the display.
Step 1 Move the large camera target to the far left corner of the table, as shown in
OL-21845-01
Adjusting the Camera Zoom
Managing CTS 1300 Hardware Setup
Figure
Cisco TelePresence System Administration Guide
8-33.
8-39