Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 109

Chapter 4 Troubleshooting the CTS 500
Step 4 Click Start in the Testing box to begin testing the secondary audio input. The DMP status is displayed,
as shown in
Figure 4-20 CTS 500 DMP Status
•
•
Note The DMP settings should match how the secondary auxiliary audio input is physically connected to the
codec.
Step 5 Click Stop to end the test.
OL-21845-01
Figure 4-20.
If you have a PC attached, the Secondary Audio Input Source PC button is highlighted. When
Secondary Audio Input Source is set to PC, the audio input is active while the presentation source
is active, both in and out of a call.
If you have a DMP attached, the Secondary Audio Input Source DMP button is highlighted. When
set to DMP, audio input is only active outside of a call if DMP is active (during business hours
defined by Cisco Unified CM).
Managing CTS 500 Hardware Setup
Cisco TelePresence System Administration Guide
4-37