Chapter 8
Troubleshooting the CTS 1300
Figure 8-14
Step 11
Automatically adjust the cameras by completing the following steps:
a.
In the Auto Brightness field, perform one of the following actions:
•
•
b.
In the Auto Color Balance field, perform one of the following actions:
•
•
In the 50 Hz Flicker Reduction field, click the Disable radio button.
c.
OL-21845-01
Camera Target Menu
If the room uses outside lighting, or has any other conditions that could cause variable room
lighting, click the Enable radio button.
If your room lighting is not variable, leave the default value.
If the room uses outside lighting, or has any other conditions that could cause variable room
lighting, click the Enable radio button.
If your room lighting is not variable, leave the default value.
Managing CTS 1300 Hardware Setup
Cisco TelePresence System Administration Guide
8-19