Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 223
Telepresence system
Hide thumbs
Also See for CTS 1000 - TelePresence System 1000 Video Conferencing:
- Hardware options & upgrade manual (142 pages)
Table of Contents
Advertisement
Chapter 8
Troubleshooting the CTS 1300
Figure 8-6
Side to side
adjust screw
Attaching the Large Camera Target to the Easel
To unpack and build the easel and large camera target:
Remove the easel, large camera target, and small camera target from their packaging.
Step 1
Unlock and slide the telescoping legs of the easel until the legs are at their full height.
Step 2
Separate the three legs.
Step 3
Raise the front legs until they are 29 inches (74 cm) high.
Step 4
Raise the rear leg until it is 31 inches (79 cm) high.
Step 5
Lock the legs into place using the leg locks.
Step 6
Step 7
Attach the large camera target to the clip on top of the easel.
Step 8
Raise the target supports on the front legs until they touch the lower part of the large camera target.
Step 9
Raise and lower the front legs until the bottom of the camera target is 32 inches above the ground.
Figure 8-7
OL-21845-01
Camera Rotational Adjustment Screws
Left
adjust
screw
Up/down
adjust
screw
shows the completed camera target and easel.
Managing CTS 1300 Hardware Setup
Right
adjust
screw
Side to side
adjust screw
Up/down
adjust
screw
Cisco TelePresence System Administration Guide
8-11
Advertisement
Table of Contents
Troubleshooting
