Downloading A Configuration Script From A Tftp Server; Troubleshooting A Downloaded Script - Dell Force10 S2410-01-10GE-24P Configuration Manual

Force10 #script delete test.scr
Are you sure you want to delete the configuration script(s)? (y/n)y
1 configuration script(s) deleted.

Downloading a Configuration Script from a TFTP Server

To download a "config script", use the
Command Syntax
copy tftp:// /
x.x.x.x
nvram:script
scriptname
Figure 3-34. Using the copy tftp Command for a Script
Force10 #copy tftp://10.16.1.56/test.scr nvram:script test.scr
Mode........................................... TFTP
Set TFTP Server IP............................. 10.16.1.56
TFTP Path......................................
TFTP Filename.................................. test.scr
Data Type...................................... Config Script
Destination Filename........................... test.scr
Are you sure you want to start? (y/n) y
Validating configuration script...
hostname "Force10"
interface managementethernet
ip address 10.10.1.33 255.255.255.0
exit
management route default 10.10.1.254
interface vlan 11
<output deleted>

Troubleshooting a Downloaded Script

While attempting to download a config script, the system validates the downloaded file. If the validation
fails an error message like the following will appear:
62 | Getting Started
.scr
scriptname
.scr
copy command, as in the following.
Command Mode Purpose
Privileged Exec Downloads the named script from the TFTP server
identified by the URL.