Dell Force10 S2410-01-10GE-24P Configuration Manual page 274

4. Assign the same virtual router ID to the port as defined for Router 1.
Force10 (Config)#interface 1/0/4
Force10 (Interface 1/0/4)#ip vrrp 20
5. Specify the virtual IP address that the VRRP function will recognize. Since the virtual IP address on
port 1/0/4 is the same as Router 1's port 1/0/2 actual IP address, this router will be the VRRP backup
while Router 1 is active.
Force10 (Interface 1/0/4)#ip vrrp 20 ip 192.150.2.1
6. Set the priority for the port. The higher the number, the more likely that the router will become the
master router in a failover. The default priority is 100.
Force10 (Interface 1/0/4)#ip vrrp 20 priority 254
7. Enable VRRP on the port for VRID 20.
Force10 (Interface 1/0/4)#ip vrrp 20 mode
Force10 (Interface 1/0/4)#exit
8. Use
show ip vrrp interface
preferences.
274 | Layer 3 Routing
and
show ip vrrp interface brief
unit/slot/port
on each router to verify