Vlan Mode Commands - Dell Force10 S2410-01-10GE-24P Configuration Manual
Sftos configuration guide
Hide thumbs
Also See for Force10 S2410-01-10GE-24P:
- Command reference manual (514 pages) ,
- Manual (42 pages) ,
- Quick start manual (31 pages)
Table of Contents
Advertisement
VLAN Mode Commands
The starting point for VLAN command syntax statements is the VLAN Commands chapter (Chapter 7) in
the SFTOS Command Reference.
Executing the
previously created VLAN (or use
VLAN mode, where you have access to commands that configure the selected VLAN:
•
To add an interface to the VLAN, use either the
full syntax is:
•
[
•
[
•
To change a dynamically created VLAN (see
(permanently configure):
•
To [reset] assign a name to a VLAN (VLAN 1 is always named Default, while the default for other
VLANs is a blank string.):
•
To configure the interface link layer encapsulation type:
•
To configure IGMP Snooping parameters for the VLAN:
•
To configure IP parameters, there are many command families:
•
To set the MTU (maximum transmission unit) size:
•
To configure the protocols associated with particular group IDs:
210
|
VLANs
interface vlan
2-4094
[no] interface vlan
]
{
[
no
tagged
native
intf-range
no
]
untagged
{
|
intf-range
— makestatic
(in Interface VLAN mode)
—
[no] name
(up to 32 alphanumeric characters)
name
— encapsulation
— igmp
— For ip routing, use
— Multicast: For IP multicast, use [
Routing Protocol (DVMRP), use [
igmp last-member-query-count
in the SFTOS Command Reference.
— IP OSPF commands, such as
Commands chapter in the SFTOS Command Reference.
—
IP PIM-DM commands (Protocol Independent Multicast—Dense Mode) commands, such
as
ip pimdm mode
Multicast—Sparse Mode) commands, are detailed in the PIM Commands chapter in the
SFTOS Command Reference.
—
ip rip
commands are detailed in the RIP Commands chapter in the SFTOS Command
Reference.
— [
]
no
mtu
576-1500
— [
]
no
ip mtu
68-1500
— protocol group
groupid
command (Global Config mode) either creates a VLAN or selects a
to delete a VLAN) and then enters the Interface
2-4094
tagged
] |
port-channel
port-channel-range
port-channel
port-channel-range
Using GVRP on page
ip address
and
ip vrrp
.
]
no
ip mcast boundary
no
]
ip dvmrp metric
, and others detailed in the IP Multicast Commands chapter
and
ip ospf
ip ospf areaid
and
ip pimdm query-interval
(default is 1500)
for an MTU value for IP protocol
or
untagged
intf-range
intf-range
}
}
220) to a static VLAN
.
For Distance Vector Multicast
.
For IGMP, use [
, are detailed in the OSPF
areaid
, and IP PIM-SM (Protocol Independent
command. The
no
]
ip igmp
, [
no
]
ip
Advertisement
Table of Contents
Troubleshooting
