Dell Force10 S2410-01-10GE-24P Configuration Manual page 99

Figure 5-68. Using the show stack-port counters Command Example on an S50
Force10 #show stack-port counters
Unit Interface
---- ---------------- ------ ---------- ---------- ------ ---------- ----------
1 Stack Port A
1 Stack Port B
2 Stack Port A
2 Stack Port B
For a summary of all stack members, use the
show switch command:
unit
Figure 5-69. show switch Command Example
Force10 #show switch
Management
Switch Status
------ ------------ ------------- ------------- --------------------- --------
1 Mgmt Switch SA-01-GE-48T
3 Stack Member SA-01-GE-48T
4 Stack Member SA-01-GE-48T
Force10 #show switch 1
Switch............................ 1
Management Status................. Management Switch
Hardware Management Preference.... Unassigned
Admin Management Preference....... Unassigned
Switch Type....................... 0x56950202
Preconfigured Model Identifier.... SA-01-GE-48T
Plugged-in Model Identifier....... SA-01-GE-48T
Switch Status..................... OK
Switch Description................
Expected Code Type................ 0x100b000
Detected Code Version............. 2.3.1.5
Detected Code in Flash............ 2.3.1.5
Serial Number..................... DE40047
Up Time........................... 0 days 0 hrs 33 mins 55 secs
The command shows pretty much the same data as the
show stack
------------TX-------------- ------------RX--------------
Data Error
Rate Rate Total
(Mb/s) (Errors/s) Errors
0 0 0
0 0 0
0 0 0
0 0 0
show switch
Preconfig Plugged-in
Model ID Model ID
SA-01-GE-48T
SA-01-GE-48T
SA-01-GE-48T
Data Error
Rate Rate
(Mb/s) (Errors/s)
0 0 0
0 0 0
0 0 0
0 0 0
command. For details on one switch, use the
Switch
Status
OK
OK
OK
show stack-port
Total
Errors
Code
Version
Manager
2.3.1.5
Member
2.3.1.5
Member
2.3.1.5
command:
Stacking S-Series Switches | 99