CLI Examples of SNTP Setup
The following examples show the major command sequences in configuring the SNTP connection.
Example #1: Configuring SNTP client mode
Figure 4-49. Configuring SNTP Client Mode
Force10 (Config)#sntp client mode broadcast ?
<cr> Press Enter to execute the command.
Force10 (Config)#sntp client mode unicast ?
<cr> Press Enter to execute the command.
Force10 (Config)#sntp broadcast client poll-interval ?
<6-10> Enter value in the range (6 to 10). Poll interval is 2^(value) in seconds.
Example #2: Configuring SNTP client port
Figure 4-50. Configuring the SNTP Client Port
Force10 (Config) #sntp client port 1 ?
<cr> Press Enter to execute the command.
<6-10> Enter value in the range (6 to 10). Poll interval is 2^(value) in seconds.
Example #3: Configuring SNTP server
Figure 4-51. Configuring the SNTP Server Connection
Force10(Config) #sntp server 10.11.8.6 ?
<cr> Press Enter to execute the command.
<1-3> Enter SNTP server priority from 1 to 3.
Example #4: show sntp client
Figure 4-52. Using the show sntp client Command
Force10
Client Supported Modes: unicast broadcast
SNTP Version: 4
Port: 123
Client Mode: unicast
Unicast Poll Interval: 6
Poll Timeout (seconds): 5
Poll Retry: 1
80
|
Management
#show sntp client