Dell Force10 S2410-01-10GE-24P Configuration Manual page 265

Figure 17-244. Configuring VLANs for OSPF
Force10 #config
Force10 (Config)#interface vlan 10
Force10 (Conf-if-vl-10)#tagged 1/0/01
Force10 (Conf-if-vl-10)#tagged 1/0/02
Force10 (Conf-if-vl-10)#ip address 10.1.1.1 255.255.255.0
Force10 (Conf-if-vl-10)#ip ospf
Force10 (Conf-if-vl-10)#ip ospf areaid 2
Force10 (Conf-if-vl-10)#exit
Force10 (Config)#interface vlan 20
Force10 (Conf-if-vl-20)#tagged 1/0/03
Force10 (Conf-if-vl-20)#ip address 10.10.1.2 255.255.255.0
Force10 (Conf-if-vl-10)#ip ospf
Force10 (Conf-if-vl-10)#ip ospf areaid 2
Force10 (Conf-if-vl-10)#exit
Force10 (Config)#exit
3. At this point, the
show ip ospf
Figure 17-245. Output of the show ip ospf Command Before Enabling OSPF
Force10 #show ip ospf
Router ID...................................... 0.0.0.0
OSPF Admin Mode................................ Disable
ASBR Mode...................................... Disable
RFC 1583 Compatibility......................... Enable
Force10 #
4. Enable OSPF for the switch and specify a router ID.
Figure 17-246. Output of the show ip ospf Command before Enabling OSPF
Force10 #config
Force10 (Config)#router ospf
Force10 (Config router)#router-id 1.1.1.1
Force10 (Config router)#enable
Force10 (Config router)#exit
Force10 (Config)#exit
Force10 #
5. Execute the
show ip ospf
command will indicate no router ID and that OSPF is not enabled:
command again.
Layer 3 Routing | 265