Adding A Lag To A Vlan - Dell Force10 S2410-01-10GE-24P Configuration Manual

4. Verify both LAGs.
Figure 11-130. Using the show interface port-channel brief Command
Force10#show interface port-channel brief
Codes: L - LACP Port-channel
LAG Status Ports
--- ------ -------
10 Up 1/0/2 (Up)
1/0/3 (Up)
20 Up 1/0/2 (Up)
5. At this point, the LAGs could be added to VLANs, as described next.

Adding a LAG to a VLAN

To add a LAG to a VLAN, you access the Interface VLAN mode with the
and you use the tagged
Figure 11-131. Adding a LAG to a VLAN
Force10#show interface port-channel brief
Codes: L - LACP Port-channel
LAG Status Ports
--- ------ -------
1 Down 1/0/20 (Down)
1/0/21 (Down)
1/0/22 (Down)
2 Up 1/0/23 (Up)
1/0/24 (Up)
Force10#config
Force10 (Config)# interface vlan 11
Force10 (conf-if-vl-11)#tagged port-channel 2
Force10 (conf-if-vl-11)#exit
Force10 (conf-if-vl-11)#
Force10 (Config)#
Force10# show vlan id 11
Codes: * - Default VLAN, G - GVRP VLANs, E - Ethernet interface, ^ - Native VLAN
Vlan Id Status Q Ports
--------- ---------- - ------
11 Inactive T E 1/0/10, 1/0/11,
or untagged command, just as when you add a port to a VLAN:
2
LAG 2 highlighted in red
command,
interface vlan
vlan-id
Link Aggregation | 173