Applying A Configuration Script - Dell Force10 S2410-01-10GE-24P Configuration Manual

Figure 3-35. Example of a Script Validation Error Message
Configuration script validation failed.
Following lines in the script may have problem:
Line 29:: permit 01:80:c2:00:00:00 any assign-queue 4
Line 30:: permit any 01:80:c2:00:00:ff assign-queue 3 redirect 1/0/10
Line 31:: permit 01:80:c2:00:00:ee any assign-queue 4
Line 36:: match cos 5
Line 44:: police-simple 500000 64 conform-action transmit violate-action drop
Line 45:: police-simple 500000 64 conform-action transmit violate-action drop
Total error Lines :: 6
The file being downloaded has potential problems. Do you want to save this file?

Applying a Configuration Script

To apply a "config script", use the
Command Syntax
script apply .scr
scriptname
Figure 3-36. Using the script apply Command
Force10 #script apply test.scr
Are you sure you want to apply the configuration script? (y/n)y
The system has unsaved changes.
Would you like to save them now? (y/n) n
Configuration Not Saved!
hostname "Force10"
interface managementethernet
ip address 10.10.1.33 255.255.255.0
exit
management route default 10.10.1.254
interface vlan 11
exit
exit
Configuration script 'test.scr' applied.
Applying a configuration script on a machine with certain previously configured features may result in an
error. This is because the syntax for entering the configuration mode that allows for editing the feature may
be different than the syntax that exists in the configuration (and was used to create the feature initially).
There are several such features.
command, as in the following.
script apply
Command Mode Purpose
Privileged Exec To do
Getting Started | 63