Dell Force10 S2410-01-10GE-24P Configuration Manual page 53

The example in Figure 3-25
reloaded if a stack exists) with SFTOS 2.5.1:
Figure 3-25. Using the reload command to upgrade to SFTOS 2.5.1
Force10 #reload
Are you sure you want to reload the stack? (y/n) y
Reloading all switches.
Force10 Boot Code...
tffsDevCreate failed.
Storing configuration files
Storing Code base
usrTffsConfig returned 0xffffffff, formatting...
Calling FORMAT ROUTINE
Format routine returned with status 0x0
Recover configuration files
CPU Card ID: 0x508245
dimInitialize returned 3
adding the default image - code.bin to the list
dimImageAdd returned -3
Boot Menu Version: 30 Aug 2006
Version 02.01.42 08/30/2006
Select an option. If no selection in 2 seconds then operational code will start.
1 - Start operational code.
2 - Start Boot Menu.
Select (1, 2):
Operational Code Date: Mon Oct 16 05:17:13 2006
Uncompressing.....
|||||||||||||||||||||||||||||||||||||||||||||||||||
Attaching interface lo0...done
Adding 40747 symbols for standalone.
PCI device attached as unit 0.
PCI device attached as unit 1.
PCI device attached as unit 2.
PCI device attached as unit 3.
PCI device attached as unit 4.
PCI device attached as unit 5.
PCI device attached as unit 6.
Configuring CPUTRANS TX
Configuring CPUTRANS RX
MonitorTask - Active
ConsoleDebugger - Disabled
(Unit 1)>STACK: master on 0:1:e8:d5:a0:57 (1 cpu, 7 units)
STACK: attach 7 units on 1 cpu
This switch is manager of the stack.
User:
Saved Configuration being applied...Please Wait....
Configuration applied successfully.
shows the boot messages when loading the switch (all switches in the stack are
Pause of up to several minutes
Shorter pause
50% 100%
Getting Started | 53