Dell Force10 S2410-01-10GE-24P Configuration Manual page 199

Each rule is appended to the list of configured rules for the list. Note that an implicit "deny all" MAC rule
always terminates the access list.
Note: You can add new deny/permit list items to an existing list, but you cannot remove previously
configured deny/permit list items. You must delete the list before recreating it as you want.
• Change the name of a MAC ACL. This command fails if a MAC ACL identified by the name
already exists:
— mac access-list extended rename
• Attach a MAC ACL identified by name to the selected interface in the ingress direction. The
parameter must be the name of an existing MAC ACL. The optional
set the order in which ACLs are applied to the interface if more than one ACL is assigned.
—
mac access-group
Force10 (Config)#interface 1/0/2
Force10 (Interface 1/0/2)#mac access-group ml-1 in
• Remove the assignment of a MAC ACL identified by name from the selected interface:
—
no mac access-group
• Display a MAC ACL and all of the rules that are defined for the ACL. The
the MAC ACL to display:
—
show mac access-list
Figure 13-157. Sample Output from show mac access-list Command
Force10 #show mac access-list ml-1
Rule Number: 1
Action......................................... permit
Source MAC Address............................. 01:80:C2:00:00:00
Assign Queue................................... 4
Rule Number: 2
Action......................................... permit
Destination MAC Address........................ 01:80:C2:00:00:FF
Assign Queue................................... 3
Redirect Interface............................. 1/0/10
Force10 #
• Display a summary of all defined MAC access lists in the system:
— show mac access-lists
Figure 13-158. Sample Output from show mac access-lists Command
Force10 #show mac access-lists
Current number of all ACLs: 3
MAC ACL Name
------------------------------- ----- ------------------------- ---------
ml-1
Force10 (Config-mac-access-list)#permit any 01:80:c2:00:00:FF assign-queue 3 redirect 1/0/10
name newname
[ ]
in
name 1-4294967295
name
name
Maximum number of all ACLs: 100
Rules Interface(s)
2 1/0/2
parameter helps to
1-4294967295
parameter identifies
name
Direction
inbound
Access Control | 199
newname
name