Verifying the configuration
Verify the configuration with these show commands, in Privileged Exec or User Exec modes:
Use the
show ip igmp-proxy
parameters only when IGMP Proxy is enabled, as shown in
Figure 17-224. Using the show ip igmp-proxy Command
Force10 #show ip igmp-proxy
Admin Mode..................................... Enable
Operational Mode............................... Disable
•
show ip igmp-proxy groups
•
show ip igmp-proxy interface
Other relevant
•
show ip igmp-proxy interface
•
show ip igmp-proxy groups
•
show ip igmp-proxy groups detail
Figure 17-225. Using the show ip igmp-proxy Command
Force10-S50V#show ip igmp-proxy
VLAN .......................................... 2
Admin Mode..................................... Enable
Operational Mode............................... Enable
Version........................................ 3
Number of Multicast Groups..................... 0
Unsolicited Report Interval.................... 1
Querier IP Address on Proxy Interface.......... 0.0.0.0
Older Version 1 Querier Timeout................ 0
Older Version 2 Querier Timeout................ 0
Proxy Start Frequency.......................... 3
Figure 17-226. Using the show ip igmp-proxy groups Command
Force10-S50V#show ip igmp-proxy groups
VLAN .......................................... 2
Group Address
---------------
254
|
Layer 3 Routing
command to display host interface status parameters. It displays operational
command:
command:
show
commands include:
{
unit/slot/port
{
unit/slot/port
Last Reporter
---------------
Figure 17-225
Figure 17-226
Figure 17-227
| vlan
}
1-3965
[
] |
[
detail
detail
1-3965
Up Time
Member State Filter Mode Sources
-------
------------ ----------- -------
]}