Displaying Vlan Information - Dell Force10 S2410-01-10GE-24P Configuration Manual

Displaying VLAN Information

The show port , show running-config
the information about the VLAN configuration. The
• (no option entered) Display summary information for all configured VLANs. See
below.
• association
•
brief
• id
•
name
•
port
See also the show
• Using show vlan Command to Display Native VLAN Members on page 228
• Using show interface Command to Display Native VLAN Membership on page 228
• Using show interface ethernet Command to Display Native VLAN Membership and Activity on
page 228
Use the following commands to display VLAN status and activity. For details, see
Information on page 112
Reference:
•
show interface ethernet
VLAN-related information.
•
show interface
managementethernet
•
show mac-addr-table vlan
VLAN.
Figure 14-198 shows the use of the commands
settings. Note in the
1 is the default VLAN, and all interfaces are members of VLAN 1 by default.):
(see Figure
Display associations to VLANs.
Display switch VLANs.
Display VLAN configuration and configure VLANs. See
Display VLAN configuration for a VLAN with optional name.
Display 802.1Q port parameters. See
commands exemplified above:
and the System Management Commands chapter of the SFTOS Command
{ |
switchport
unit/slot/port
{ |
ethernet
unit/slot/port
| port-channel {
1-128
: This command reports the MAC addresses in the specified
VLAN_ID
show vlan brief output that VLAN 1 exists even though it was not configured (VLAN
14-198, below), and
command has the following options:
show vlan
Figure
| }: Each parameter yields different
1-3965
switchport |
unit/slot/port
{
| brief } | switchport
show running-config
show vlan commands provide most of
Figure
Figure 14-200, below.
14-201, below.
Viewing Interface
| } | |
loopback
1-3965
}
and to display VLAN
show vlan brief
14-199,
VLANs | 233