When converting from a Routing image to a Switching image, you must interrupt the reboot to revert the
switch to factory defaults, as shown in
Figure 3-27. Restoring Factory Defaults when Converting from Routing to Switching Image
Force10 #reload
Management switch has unsaved changes.
Would you like to save them now? (y/n) y
Configuration Saved!
Are you sure you want to reload the stack? (y/n) y
Reloading all switches.
Force10 Boot Code...Version 01.00.26 06/03/2005
Select an option. If no selection in 2 seconds then operational code will start.
1 - Start operational code.
2 - Start Boot Menu.
Select (1, 2):2
Boot Menu Version 01.00.27 11/18/2005
Options available
1 - Start operational code
2 - Change baud rate
3 - Retrieve event log using XMODEM (64KB).
4 - Load new operational code using XMODEM
5 - Display operational code vital product data
6 - Update Boot Code
7 - Delete operational code
8 - Reset the system
9 - Restore Configuration to factory defaults (delete config files)
[Boot Menu] 9
[Boot Menu]
[Boot Menu]
[Boot Menu] 8
Managing the Configuration
This section contains the following major subsections, in this order:
•
Clearing the Running Configuration on page 57
•
Saving the Startup Configuration to the Network on page 57
•
Configuring from the Network on page 58
•
Restoring the System to the Factory Default Configuration on page 58
•
Resetting the Pre-configured System on page 59
56
|
Getting Started
Figure
3-27:
Select 2 and press Enter within 2 seconds to invoke the Boot Menu.
Select 9 and press Enter.
Select 8 and press Enter.