Dell Force10 S2410-01-10GE-24P Configuration Manual page 119

— Lag—This port is a member of a port-channel (LAG).
— Probe—This port is a probe port.
• The Admin Mode column shows if the port is enabled or shut down. To enable the port, see
an Interface on page
• The Physical Mode column displays Auto if the port is set to auto-negotiate (Duplex mode and speed
will be set from the auto-negotiation process.) To force a change in the setting, see
and Duplex Mode on page
• Physical Status—Indicates the port speed and duplex mode.
• The Link Status column displays Up, Down, or Detach.
The two optional 10G ports (numbered as ports 49 and 50) in the S50 always appear in the list, so
when they are not installed, this column lists them as Detach. Rather than physically inspecting the
rear slot to determine if the 10G module is installed, you can use the
Figure 7-85, to learn more.
• Link Trap—This object determines whether or not to send a trap when link status changes. The factory
default is enabled.
• LACP Mode—Displays whether LACP is enabled or dis
The SA-01-10GE-2P model number shown in the
Figure 7-85. 10G Module Listed by the show slot Command
Force10 #show slot
Admin
Slot Status State
----- ------ ------- ------- -------------------------------- --------- -----
1/0 Full Enable
2/0 Empty Enable
3/0 Empty Enable
Note, in the show slot report above, that the presence of a 10G module in stack member 1 is indicated both
by the Status field indicating Full and the Power State field indicating Enable. In contrast, the empty slots
in stack members 2 and 3 are indicated by the Status field indicating Empty and the Power State field
indicating Disable.
After you determine the status of physical interfaces, you can access the Interface Config mode to
configure the designated interface.
120.
120.
Power Configured Card
State Model ID
Enable SA-01-10GE-2P
Disable SA-01-10GE-2P
Disable SA-01-10GE-2P
show slot
abled on this port.
show slot report is that of the 10G module.
Hot
Pluggable Down
No
No
No
Enabling
Configuring Speed
command, as shown in
Power
No
No
No
Configuring Interfaces | 119