Dell Force10 S2410-01-10GE-24P Configuration Manual page 30

Step Task (continued)
Enter Line Config mode by logging in, entering Privileged Exec mode (enable command), Global Config
5
mode (config command), then lineconfig. In Line Config mode, use the serial timeout command to set the
console inactivity timeout (0 for no timeout; up to 160 minutes):
User:admin
Password:
Force10 >enable
Password:
Force10 #configure
Force10 (Config)#lineconfig
Force10 (Line)#?
exit
serial
session-limit
session-timeout
transport
Force10 (Line)#serial ?
baudrate
timeout
Force10 (Line)#serial timeout ?
<0-160>
Force10 (Line)#serial timeout 0
Force10 (Line)#exit
Force10 (Config)#
6 To display serial (console) port configuration, enter the command show serial:
Force10 #show serial
Serial Port Login Timeout (minutes)............ 30
Baud Rate (bps)................................ 9600
Character Size (bits).......................... 8
Flow Control................................... Disable
Stop Bits...................................... 1
Parity......................................... none
For more on setting serial settings, see the hardware guide for your system or the System Management
Commands chapter in the SFTOS Command Reference.
The default CLI user, admin, has read/write access, with no password until you create one. For details, see
Creating a User and Password on page
Password on page
30 | Getting Started
Figure 3-2. Using the Line Config Mode and the serial timeout Command
To exit from the mode.
Configure EIA-232 parameters and inactivity timeout.
Configure the maximum number of outbound telnet
sessions allowed.
Configure the outbound telnet login inactivity
timeout.
Displays the protocol list to use for outgoing
connections.
Set the serial baudrate.
Configure the serial port login inactivity timeout.
Enter time in minutes.
Figure 3-3. Using the show serial Command
38.
36. There is also one mode-level password. See Setting the Enable