Showing Network Settings; Displaying Supported Features And System Up-Time - Dell Force10 S2410-01-10GE-24P Configuration Manual

Showing Network Settings

Execute the
modes. The resulting display, as shown in the example below, displays all the settings relating to IP-based
management connections to the switch. The data includes the management IP address, subnet mask,
default gateway, MAC information, etc., as shown below:
Figure 3-7. Using the show network Command to Display Network Settings
Force10 #show interface managementethernet
IP Address..................................... 10.10.1.151
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.10.1.254
Burned In MAC Address.......................... 00:01:E8:D5:A0:39
Locally Administered MAC Address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Network Configuration Protocol Current......... None
Management VLAN ID............................. 1
Web Mode....................................... Enable
Java Mode...................................... Disable
For details on setting up the management address, see
also Setting up a Management Connection to the Switch on page
Note: SFTOS v. 2.3 replaced the show network command with show interface
managementethernet.

Displaying Supported Features and System Up-time

The following is an example of using
34 | Getting Started
show interface managementethernet command from either the User Exec or Privileged Exec
Setting the Management IP Address on page
to display all supported features and system up-time:
show version
28.
39. See