Snmp Traps - Dell Force10 S2410-01-10GE-24P Configuration Manual

SNMP Traps

SNMP traps are the messages that are sent to designated trap receivers; they also appear in the report
generated by the
Figure A-269. A replication of the trap also appears in the System log, as described in
SNMP Trap Log on page
Figure A-269. Using the show logging traplogs Command
Force10 #show logging traplogs
Number of Traps Since Last Reset............... 60926
Trap Log Capacity.............................. 256
Number of Traps Since Log Last Viewed.......... 59852
Log System Up Time
--- ------------------------ -------------------------------------------------
0 3 days 10:23:55
1 3 days 10:23:55
2 1 days 05:27:21
3 1 days 05:18:11
4 1 days 05:18:11
5 1 days 05:18:10
6 1 days 05:18:09
7 1 days 05:18:09
8 1 days 05:18:07
9 1 days 05:18:07
10 1 days 05:18:05
11 1 days 05:18:04
12 1 days 05:18:02
Note that the report states that the trap log capacity is 256 traps. So, if the capacity is reached, the log
wraps; in other words, newer traps replace the oldest ones.
For more on SNMP management, see the
see the Syslog chapter, most specifically
show logging traplogs
106.
Trap
Last or default VLAN deleted: VLAN: 10
Last or default VLAN deleted: VLAN: 1
Link Up: Unit: 1 Slot: 0 Port: 48
Failed User Login: Unit: 1 User ID: ker.
Failed User Login: Unit: 1 User ID: ker.
Failed User Login: Unit: 1 User ID: th.
Failed User Login: Unit: 1 User ID: ker.
Failed User Login: Unit: 1 User ID: ngth.
Failed User Login: Unit: 1 User ID: % Inva
Failed User Login: Unit: 1 User ID: ngth.
Failed User Login: Unit: 1 User ID: ker.
Failed User Login: Unit: 1 User ID: ngth.
Failed User Login: Unit: 1 User ID: ker.
command, an abbreviated sample of which appears in
Setting up SNMP Management on page
Displaying the SNMP Trap Log on page
Displaying the
71. For more on logging,
106.
RFCs, MIBs, and Traps | 293