Dell Force10 S2410-01-10GE-24P Configuration Manual page 258

Figure 17-232. OSPF Example Network Diagram: Inter-area Router
1. Enable routing for the switch.
Figure 17-233. Enabling Routing for the Switch
Force10 #config
Force10 (Config)#ip routing
2. For ports 0/2 and 0/3, enable routing, and assign the IP:
Figure 17-234. Enabling Routing for Ports
Force10 #config
Force10 (Config)#interface 1/0/2
Force10 (Interface 1/0/2)#routing
Force10 (Interface 1/0/2)#ip address 192.150.5.2 255.255.255.0
Force10 (Interface 1/0/2)#exit
Force10 (Config)#interface 1/0/3
Force10 (Interface 1/0/3)#routing
Force10 (Interface 1/0/3)#ip address 192.150.5.3 255.255.255.0
Force10 (Interface 1/0/3)#exit
3. Specify the router ID and enable OSPF for the switch. Disable "1583compatibility" to prevent the
routing loop.
Figure 17-235. Specifying the Router ID and Enabling OSPF
Force10 (Config)#router ospf
Force10 (Config router)#enable
Force10 (Config router)#router-id 192.150.9.9
Force10 (Config router)#no 1583compatibility
Force10 (Config router)#exit
Force10 (Config)#
258 | Layer 3 Routing