Dell Force10 S2410-01-10GE-24P Configuration Manual page 121

Figure 7-86. Using the show port Command to Verify Port Settings
Force10 #show port 1/0/30
Interface Type Mode
-------------- ------ -------
1/0/30
The Link Status field indicates whether the port is passing traffic. Of course, at some point in the process
you must connect ports for that field to indicate Up.
Note: Ports 45 through 48 are a special case in the S50. The port IDs are shared between a
set of four copper 10/100/1000 ports labeled 45 through 48 and a set of four optional fiber 1G
ports. When the fiber 1G ports are installed and connected, they take precedence. For details,
see the S50 hardware guide.
The following table describes the expected interface status of two directly connected copper ports based on
the configured or auto-negotiated speed and duplex settings.
Table 7-4. Expected Interface Status of Directly Connected Copper Ports
10 Mbps
Port A Half
Up
10 Mbps Half
Up
10 Mbps Full
Down
100 Mbps Half
Down
100 Mbps Full
Down
1 Gbps Full
Up
No
Auto-negotiation
Auto-negotiation Up
Admin Physical Physical Link
Mode Status
-------- ------ ------ -------
Enable Auto 100 Full Up
100
10 Mbps Mbps
Full Half
Up Down
Up Down
Down Up
Down Up
Down Down
Up Up
Up Up
Link LACP
Status Trap Mode
Enable Enable
Port B
100
Mbps 1 Gbps No
Full Full Auto-negotiation Auto-negotiation
Down Down Up
Down' Down Up
Up Down Up
Up Down Up
Down Up Up
Up Up Up
Up Up Up
Up
Up
Up
Up
Up
Up
Up
Configuring Interfaces | 121